|
Fuel recommendation for 383 sbc | Yellow Bullet Forums
Just got my 383 build done and in the car. Have not got to test it yet...it currently has ethanol free pump 93 in the tank. Looking to see what it might need for octane. Its a 383 with ported Profiler 72cc aluminum heads, Probe 8cc dome pistons. Cam is a Jones Hyd roller...240-250@.050...
Caltrac adjustment - Yellow Bullet Forums
Hello, Have a 74 nova, sbc 406, caltracs, Typically runs 6.50-6.70s depending on the air. It seems to be unloading the tires while the front end is in the air, It gets worst when the track and air come around. Its not all the time. Only think that seems to help is to tighten up the extension...
65 Nova “Patina” Small Tire Build | Yellow Bullet Forums
This is our 65 Nova home built small tire Hot Rod. This was a rust bucket we found sitting next to a barn on a farm out in Nebraska. We brought her home and fixed every bit of rust, knocked out all the dents and blended in the paint to match the original patina as we found her. We bent up the...
WD-40 tire treatment? - Yellow Bullet Forums
It hasnt affected the longevity of the tire. I wound not recommend it on big cars. If you are running a big car slick more than 1-2 seasons, you are asking for inconsistencies due to the beating that the tire endures on a big car. Clark Midwest based in Nebraska/Iowa Reply Like
What's a good size winch for car trailer? - Yellow Bullet Forums
Hi, I'm looking to buy a winch for my trailer, my car weighs 3000 pounds. What would be a good size winch to pull the car up onto the trailer? Im using a 2500 now and it struggles. There's a sale on 5000 pound winches and the next size up is 9000. What are you guys using? Thanks!!
nitrous mother bottle cost - Yellow Bullet Forums
Matheson in oklahoma and here in nebraska, 450 to buy 1st bottle then 150 trade in for 50lb.
68 Camaro rear wheel size | Yellow Bullet Forums
Can anyone tell me what the widest rim/tire combo I can get under my 68 Camaro would be. I have 15x8's on it now with a 275 drag radial. I am planning on building a fab 9 and removing the 12 bolt, still utilizing the factory suspension, but did not want to mini tub unless absolutely necessary...
what size winch for an enclosed trailer | Yellow Bullet Forums
The only time I EVER had to use a snatch block on my 2500lb winch to get any vehicle up, I picked up a 57 chevy in Nebraska my grandfather wanted. It was a farm field find, 4 flat tires and car sunk to the frame in the field...and once I got it popped out of the 4 ruts all 4 tires locked up tight too. It single line pulled it just fine upto the trailer ramps, then once it started dragging up ...
Main and Rod bearing prep - Yellow Bullet Forums
Housing bores and the back side of bearing shells can be cleaned with alcohol prior to assembly. ACL bearings are manufactured in Australia. Clevite is still manufactured in Nebraska, USA but that is in the process of being changed, to Mexico in the very near future.
open trailer wind delfector - Yellow Bullet Forums
anyone know where to get a nice , yet inexpensive wind screen/ deflector, for an open trailer ? I've seen some neat ones going down the hwy, where'd they get them? looking to protect the car on the trailer. Not looking for 6 ft tall, 3-4 ft tall, aero design.
|
